Braun WK600 Cordless Electric Kettle "metal working" Questions

...it do not have any obvious way to fix it (locking clips or screws) and it was just inserted on the metal part ..than you can use some kind of glue for plastic and fix it back again .a super -glue ...

working - its almost new! My kettle is almost new, and after making a cup of tea one morning it wouldn't heat water when I went to make another cup a few minutes later. It didn't overheat or anything.

...and after pulling the base off I found that the switch was ok but the problem lay with the two bi-metallic thermal overload switches that are connected to the heating element. I managed to reset ...

working fine. However, lately I do not feel that it boils to a high enough temperature for a long enough time as when for example a cup of tea is made it is fairly hot (not very) but then very quickly

...working. The power light at the base is operating and on. However, it will not get hot, not even warm. Is it a blown fuse somewhere? Have had same problem several times. My fix was to remove the five ...

...that about the same size with a funnel design on the bottom and little holes in the bottom, a flat metal thing with a flat metal stick in the center fits inside the middle part and it also has holes ...

...working, although an electrical sensing device indicates the base charging unit is receiving power. I've disassembled the bottom of the pot but can find nothing obviously wrong -- in fact, it looks ...

...working fine, our Aroma water kettle wouldn't turn on, anymore. The switch would stay in the "on" position, but the light wouldn't go on. No heating, obviously. Actually, I ...

...light and power the heater element. Where the wires connect to the switch mechanism, there are two metal tabs that stick out in opposite directions from the center. When the switch is pushed down, ...