Alpine MRD-M300 Car Audio Amplifier "amp settings" Questions

amp settings for a 500/1 to run a jl audio 13w6v2 d-4 ! amp settings for subwoofer wired series ! an amp setting for sub wired parallel ! series would be 8 ohm an parallel would be 2 ohm ! an can this

...settings on amp to lower power easiest way to set amp is (turn the knobs on amp all down turn up your system to the level you listen to normally and then set the amp knobs for bass turn knob slow to ...

...have caps before your power going into the amps, might not be getting enough power, check your settings on the amp, gain output make sure it in stereo and not mono and check your crossover, or ...

kole amp in protect mode? I have a kole amp nitric XP2-2000 hooked up to two Memphis subs the subs are dual voice coil 4ohms and can handle 500 watts RMS when i tried to bridge the subs to the amp the

i have a fosgate 15' sub and a fosgate t1001bd amp in my chevy tracker, how should the amp be hooked up and where should the ohms be set? i have a fosgate 15' sub and a fosgate t1001bd amp

what is a good amp settings for my amp it depends on what amp you have, everry amp has to be set (Differently)

...will not play the left channel?? HOw do i fix? is the gain turned up on the amp, is the sub set to low frequency, maybe your head deck settings have bass/subwoofer off or bal set to front of the

The amp turns on and the lights come on and all my wires are hooked up correctly but i still have no sound? Make sure your RCA's are hooked up, the take a DMM set it to AC volts, turn the deck up ...

is not playing sound amp comes on like normal. tells me temp volts and where it used to show an (a) i guess thats for amps it shows ------ instead of a number. can you help? check your signal going to

how to bridge a ppi amp Hello, The PCX-1500 is a single channel amp, it can't be bridged. I realize that it has two sets of speaker outputs but electrically it only has one output. The connections are