Goodman GMS90703BXA Heater "wire capacitor blower motor" Questions

...wire it thanks for your time John if the resistor you refer to is the capacitor, yes it dies require the capacitor and no it cannot be bypassed. I fyou have power to the blower and it does not start ...

...blower motor capacitor with Volt meter that reads microfarads. It should be within 10 percent of what its rating is. Most residential blower motor capacitors are 5mf to 10 mf. You will have to turn ...

...wire to gound . depending on motor, other colors would be medium and medium high is so equipped. if motor gets hot after a while check for a capacitor, they have a tendency to get weak, replace with ...

...capacitor, or the motor itself is bad. Try jumping the L1 wire with the low voltage motor wire , if this gets the motor running the control board is bad. If the board apperas fine and you have power ...

...to the same colors to the becket burner and the two brown wires are connected the the same positions on the capacitor all just as the original blower motor. Do you think it might be the relay ...

...capacitor but I don't believe he rewired them properly, could you please provide me with the proper wiring diagram new blower motor has 2-brown wires 1-black,1-red,1-yellow,1-blue and 1-orange wire ...

...FAN(Green) Then your looking at a Bad Blower Motor (AND, OR) A bad Capacitor. Hopefuly it's just a loose wire or bad capacitor,, the motor isnt cheap..!!!STAY SAFE!!!!!.. and best of luck to

on. Heating elements get hot but again no blower fan. model 3500A816, SN 079076008 Look for two brown wires on the blower motor. They go to the start capacitor. Your unit does not need a run capacitor

...capacitor or the blower motor is going bad. It is a good idea to change them at the same time. Copy the model and serial number down and take it to a HVAC supply house and they can sell you the motor ...

blower motor. On a direct drive motor there is a small silver capacitor. It should have 2 wires going from it to the motor (usually brown). This probably needs replaced and should be replaced with the