Goodman GMS90703BXA Heater "cleaning heating element furnace" Questions

...furnace with electronic ignition. Can't find a brand name or model anywhere. Intermitently the thermostat calls for heat, blower fan comes on, igniter comes on, and then either all the heating ...

makes a noise when turned on.. sounds like fan or fan motor. I would make sure the heater is unplugged then remove backscreen and foam filter. Carefully clean firter with warm water and alittle dish ...

...heating element shuts off and it blows cold air for the rest of the time. It doesn't stop because it reached the temperature it was supposed to because my house stays cold all the time and i would ...

...heating element not unlike a light bulb filament (and shown in the photo above), to ignite the gas burner. It is important to understand some of the other components of a modern furnace that you will ...

...furnace, one or more of the individual heating elements could be not functioning correctly, lowering the furnace total output which in turn has to run longer to produce the amount of heat required to ...

...element is cooled down. It could be a venting problem. Make sure the vents are clean. When it's not lit, air gets into it. When you light it, it slowly uses what air it has and it starves for oxygen. ...

...heating element seem to work, but not well. With the thermostat set at full hot, it just barely throws out any heat at all. ??? As I'm sure you already know, Empire Comforts Systems, no longer makes ...

...heating element lights up when the unit is getting ready to start heating (blower has been running about 10 seconds or so and continues fine through all of this), but the element turns off prior to ...

...heating element... the pilot light will light, thus lighting all the burners and kicking on. However, next time it shuts down, often the same process has to be done when it wants to start up again or ...