buy at CVS or any pharmacy for less than 2 dollars) and cotton swabs to clean both the top sensor and the bottom sensor-make sure to turn off the power FIRST, and make sure to allow a minute or so for
buy at CVS or any pharmacy for less than 2 dollars) and cotton swabs to clean both the top sensor and the bottom sensor-make sure to turn off the power FIRST, and make sure to allow a minute or so for
...2 and 3 (and I read the instructions from start to finish) it did not re-engage the motor. So, I went in and took it apart to verify functionality. The motor works because it will spin when a voltage ...
Question about Datamax Office Equipment & Supplies
2 datamax prodigy plus label printers which i would like to print tags with but have no idea what software to use to run it. I would like to print it as direct thermal, got the direct thermal tags but
...2 on back, three at front and one middle right 7) Carefully remove speaker cable (Red Connector) and lift up plastic casing, leaving printer uncovered. 8) Re-Seat Encoder Strip into guide. (The ...
Question about Sharp Office Equipment & Supplies
...2 days to be sure it is COMPLETELY dry. reassemble, charge the ink, do the printers head cleaning, and boom. back in business. this works 90% of the time buy a canon,,,, hps ****, hp is always making ...
2 plastic connectors each with four or five wire, then remove the ribbon cable from the slot. There is a screw in a clamp that holds it tight, loosen that and make sure all the wires are clear. Moving
...2 small watch batteries placed on top of each other and wired into the board. I have disconnect this component and put it all back together. After all that, its not made any difference and i'm still ...
Question about Sharp Office Equipment & Supplies
2-1 inch of up and down play on the back side of the belt when printing, we figure it is due to the front side under tension as it is pulling the carriage. We are thinking of replacing the main ribbon
...2 years but don't use it a lot. Not sure why all of a sudden it stopped working. It could be that someone has tried to update the firmware and has interrupted the process before it had finished.If ...
36 questions posted
Usually answered in minutes!
1,105 Questions
603 Questions
557 Questions
331 Questions
354 Questions