Hitachi 50UX58B 50" Rear Projection Television "tube tv picture shrinking" Questions

...tube going out? The picture shrinks in and out all the way back and forth when tv is turned on. Then after a while it goes to normal but the very edges bounce around Not ur tube.Ur convergence,dying ...

tube. Could this guy be full of it and only be trying to sell us a new TV? The fluid is a fairly easy replacement. They just need to remove the CRT with the bad fluid and drain the old fluid and clean

...tube has gone bad. Then the once the TV warms up it just comes and goes. This is a common problem with this model and a fairly easy fix. You can get parts and a photo instruction guide from ...

picture from video input. The power light stays on and does not blink. When the tv is turned off, there is a small flash in the center of the screen before powering off. Could this be the fuses or the

...tv 9p5534c102 55" picture , tube problem the picture of the phillips magnovox began getting smaller and then bigger at first. it has sound color is reddish and dark NOT EXPENSIVE POWER SUPPLY PARTS ...

...picture.. I have a Mitsubishi VS-45VA2 The TV works fine except over the past month the picture began to shrink from the bottom to the top and now only the top 8" of the picture cane be seen. Any ...

TV screen shrinking from top to bottom. My mitsubishi vs-45607 45 inch screen keeps shrinking then pops back to normal. This happens continuous. I was thinking the picture tube was about to go. Is ...

...TV. My hitachi 50UX58B was working fine, but suddenly the red image appears to be out of focus with the G and B. The red part of the image looks shrinked in the middle and going out of the screen ...

Tv makes a loud "screaming" noise. Started out only after a while. Could unplug for a few hours then it would take a while to come back. Now is instant as soon as the picture comes on. Seems to ...

tv. Actually the real problem is that, some parts in the board may have become weak or the molded part in the board may have fallen down ,so changing that particular part or molding again may fix that