Hitachi 53FDX01B 53" Rear Projection Television "clear tech tv remote" Questions

TV was on but picture wasn't as clear. I pressed the "device" button and the TV immediately went to snow. Now I don't get a response with pressing any buttons on the remote or any buttons on

...tv. Cannot reset convergence without remote. The remote receiver will be in one of two places: 1) in the front keyboard(you should see a clear lens) 2) Look at the three large lens for the picture ...

...clear. I'm going to take a stab at this out of the dark but okay! 1) is there an 'Aspect' or a 'picture size' button on your hand held remote control? 2) If you scroll through your 'On Screen Menu's' ...

...tech, now computer engineer too), because the entire TV is controlled by software. There are tons of secret codes and key sequences (from the remote) which factory repair technicians can use to ...

clear throughout day although not as bad! I had a similar problem with a similar model by Panasonic. Unfortunately you will need a certified tech. to pick it up and repair it at there shop. It cost me

...tv on sometimes its on a different channel. Any help will be greatly appreciated. Sincerely, Bentley oK, FIRST rule out if it is the remote or the set. Place the remote in a drawer or away from the ...

...clear this up: Set turned off and using Sony original remote: Display, 5, volume up, power-----listen carefully this should take you to the tech menu. hit 8 and reset should appear on the screen in ...

tech supportand they said unplug the TV and plug it in after about 5 minutes. I didthat and now it went from bad to worse. No picture at all. I have whiteand black static on the screen that also has a

...times over 5 years under the extended warranty. After watching the tech, who was good, but under time constraints, it was clear that most anyone could do it if they could read and follow

...tv warms up and once in awhile it actually clears up for just a minute or two,then goes back to the same problem with the original Mitsubishi remote go into the customer menu and to the Convergence; ...