...pull forward and drop down. Now you should be able to see the projectors. I used q-tips and alcohol to clean the dustr off of them. (I went over them with the power on so i could see if there was any ...
Question about Quartet gbc Televison & Video
...pull down on the screen. If this slot is damaged, then the internal spring inside the roller will lose tension. The fix is to pull out the screen & roller assembly, roll it back up manually, then ...
Question about Hitachi Televison & Video
projector? Is it something that a novice/avg. joe can fix? What should I expect to pay a repairman? Is the repair worth it? Thanks In Advance [email protected] Sounds like a convergence promblem
...pull forward and drop down. Now you should be able to see the projectors. I used q-tips and alcohol to clean the dustr off of them. (I went over them with the power on so i could see if there was any ...
...Projector Several days ago I ask whom every could help me.On the broken LINES on the bottom third and top third of my of my green gun all though my red and blue guns can be be adjusted the general ...
...down, left, and right. If you can't move them in all directions your convergence chips are bad and should be replaced. This is a common problem. Solution #1 You need to replace the convergence chips ...
...Pull out the tabs and remove the screw on eachside. Once that is done remove the speaker cover. The two screws at the bottom are the only screws and you just have to wiggle the facing off by pulling ...
...pull one side of the resistor out of the board so you can check it out of circuit. they will usually have the value in Ohms, printed directly on the resistor, but you may have to use the resistor ...
Question about Sony Televison & Video
down from the rest of the screen. I have tried to adjust it back up using the convergence control on the remote control but it does not move it. The red projector will stay like this for about an hour
Question about Hitachi Televison & Video
...projector lens. This gives you access to the RGB LED'sAt this point is where I start going over everything with the compressed air till I dont see any more dust flying around. This is also why I ...
49 questions posted
Usually answered in minutes!
727 Questions
631 Questions
405 Questions
415 Questions
357 Questions