Canon LC-3175 Laser Fax "meaning error code 2" Questions

error code 021 I have an error code 021 on a panasonic UF-585 Press Function 7 monitor slowly 4 times * 6 scroll down to SHIPMENT SET set 2 wait for the fax to initialize and come back to READY Error ...

...error code is T/R it is saying that I should turn off power can anyone plz help me to fix this problem how can I remove that code i can remove your error.t&r error means transmition and recieving ...

Error code comes up on our Canon IR-C5180i Error code is "E000004-0401 Can you tell me what this means?? K.Edwards Check the fuser, either one of these problems 1 lamp 2 thermistor 3 thermofuse 4

error code related to fixing unit trouble, in this case with temperature that is too low after the copier is out of standy mode. You can try to reset the error over service mode: press asterix key (*)

...CODE 420 The error that you are receiving means that the machine goes to receiving mode, but receives no command from the transmitting side. The problem is not with your machine, but from the party ...

listen for the warm up cycle to go through it's process. if the error code comes up immediately after turn on the it's your thermal fuse or a thermistor. if after warm up cycle then it's a heater lamp

...error code 5100" on my screen. Also, the off/on button is flashing green and the alarm button is flasing yellow. I just replaced the ink cartridge after receiving the low ink message. I have ...

...error code 407..Please help? Thank you. The message means: 407 No confirmation from the receiving station for the previous page sent. Wait a few minutes and send again. This can mean 2 things 1) you ...

...error code ##0103 on Canon LC3175 when receiving. What does it mean? 1) The user telephone number of the other party has not been registered for the autodialing function of the machine. or 2)The user ...

...error code t/r Toshiba capasee ii mean plz help me the T/R error showing capasee 2 reason 1st. Transducer OR 2nd. pulsor board 1st Solution you change a Transducer and remove the error if not remove ...