JVC LT-40X776 40 in. LCD HDTV "tv volume problems" Questions

...TV buttons. Nothing works. Not the volume, channel, power, etc. Remote is not reporting. Unable to turn off. Have to unplug power. TV was unplugged for 24-hours. Problem remained. I would either call ...

...Volume minus" at the side of TV followed by pressing the power button like you would normally when turning on the set. This may get it back up and running if the problem is with the main board. If ...

...volume works, when i turn on the screen there is a change in the screen but no picture. what could be the problem. The most common reason for this is a faulty backlight controller. This can be due to ...

...Volume (-) buttons, but I still have no picture. Then I removed commercial power from the TV for 5 min., still no picture. Is there something I can still do? Or is this TV a lost cause? Hello, I too ...

volume works good **** the image dosent turn on Check the middle Board on the TV. Look at the little 8 pin ICs for signs of damge (I expect it to be obvious). If you find damage, you got the problem..

...TV remote control for is possibly Volume, or Picture controls. I have found your user manual, and a JVC training and service manual, for an LCD TV. Use these to troubleshoot, your problem. Please ...

...TV. Illumination Lamp comes on but no sound nor picture. We cannot turn off the set. After approximately 1 minute the Illumination lamp starts blinking. Set has worked well for 9 months. A few times ...

...TV, the volume is much louder and maximum volume of 50 on the volume bar is very loud, but once we switch back to watching the TV the volume is much quieter. How can we adjust the TV to get more ...

TV volume. Fixed volume will have the cable box output only one volume level, letting the TV do the adjustment. Just go through your cable box setting and look in the audio settings. Hope This helps..

TV as the main volume control try to lower the volume from the cable box, maybe to mid volume. If you are using the Cable box as the main volume try doing the opposite from the above.. Hope this helps