...power is off put your fuse in there should be no spark and switch on if the fuse still blows you have faulty gear If you're replacing fuses with power applied it may be no mystery why they blow. On ...
...power section, and I have seen the fuse holders separate from the board. These were the 2-piece (per fuse) clips that solder to the board and the fuse clips into them. I'm not sure if you are talking ...
Question about Audio Players & Recorders
...fuse/fuses mounted in clips on the power supply board. If yours is anything like the one a picked up for one of my bands, you can take the bottom plate off and see everything inside. Look for where ...
parts POWER WILL NOT COME ON All amps comes with fuses near to the power supply, the yamaha's fuses will be inside the amp. check the fuses if the fuses are not blown than the power supply must be ...
...fuse, then power up. If the fuse blows, the problem is on the board and is very likely beyond your control (bad chip, tin whiskers, etc.). If fuse doesn't blow, power down, wait 15 seconds, attach a ...
...power cord fuse blowing the fuse in the power cable, as it will turn on but then off again instantly, I then changed the fuse in the lead and it did the same. This could be a faulty power cord, ie: ...
...fuse follow the input power lead wiring, it sould be near a power transformer or in the power supply, if not it maybe in the power switch itself, depending on what country you are from some fuses are ...
Question about Technics Audio Players & Recorders
...fuse in power supply blowout. when i hit power on button the fuse in the power supply blowout. Fuses blow when there's an overload. This is most likely caused by a semiconductor device(s) shorted. In ...
Question about Audio Players & Recorders
...fuse inside the power transformer. You would have to replace the transformer. Measure the primary side resistance, as well as the secondary side. Both the primary and secondary should read between ...
...fuse a shorted power transistor at the circuit will blown the fuse you need to replace faulty transistors before putting up a new fuse...check also the diode at the power supply section ,faulty diode ...
35 questions posted
Usually answered in minutes!
59 Questions
46 Questions
36 Questions
35 Questions
26 Questions