Question about Printronix Matrix Office Equipment & Supplies
...logic brd is faulty most probably most probably logic board having fault. confirm first what is issue is coming from below method: 1. hammer voltage 1coming on all connection 2.remove all connection, ...
Question about Printronix Matrix Office Equipment & Supplies
When printronix printing starts after 15 to 20 mints printronix given the testing hardware error how to resolve logic card is faulty
Question about Printronix Matrix Office Equipment & Supplies
...faulty scanner or logic board. although a faulty print head can take out a logic.check that there is no burning smell or damage evident on the underside of the print head before trying a ...
Question about Tally Office Equipment & Supplies
FAULTY IN LOGIC CARD PLZ CHANGE THE HAMMER DRIVER IC IN LOGIC CARD LINE PRINTER 6306 showing HAMMER VOLTAGE 1 ERROR PI.TELL ME WHAT CAN I DO. MAIL ID [email protected] hammer voltage 1 in
Question about Printronix Matrix Office Equipment & Supplies
...this error it says error in scanner turn of scanner and error code is 61,34,0 Normally MP160 cannot scan is either USB cable faulty, LOGIC BOARD ASSY faulty, software corrupted or SCANNER UNIT
...fail and make a burning smell. Could be a faulty voltage regulator supplying the logic board or a fault in a power ...
logic board going faulty and sending too much voltage to the print head. You will need a new print head and main logic board. This would probably cost more than the machine is worth. Buy a new printer
logic board is faulty? from HK Could be the wire saddle on the harness, sometimes they are wrapped too tight around it and causes CD30. Run the output 03 131 to turn it on and 181 to turn it off. Hope
FAULTY It could be the problem with your Hammer bank/ Hammer bank cable or MLC, Some cases dusty hammer bank . Hammer 1 is usally the logic board. One of the driver fets have given up the ghost. A new
...off , every thing quiet down. could not turn on. this problem could be caused by settings on printer driver setup or a faulty USB cable. but it also can be a faulty logic board in the printer as
145 questions posted
Usually answered in minutes!
31 Questions
21 Questions
20 Questions
10 Questions
4 Questions