Question about Behringer Music
channel will just stop working. Sometimes a restart gets is up again.... Whats the deal?! The PMP has an electronic overload protection. If you overload one or the other of the outputs, it trips
When I boot up my DDX 3216 - all channels go overload... When I boot up my DDX 3216 - all channels go overload an some digital noise is produced? After rebooting 10-20 times, it suddenly works? Any ...
...any channel. DMX and channel data lights show OK. Fuses OK. The Triacs are probably blown. If you overloaded this OR tried to drive lights that were NOT incandescent or used transformers this will ...
disturtion in one left channel and bad quality in right channel Make sure you are NOT overloading (clipping) due to excess signal into the transmitter end of this unit. Reduce the gain INTO the fixed ...
...overload light is constantly lit. No sound from either channel (just a faint hum when volume slider approaches max level setting). All other channels work as intended. Power amp output is clean with ...
Question about Mackie Music
...channel overload lights come on as soon as power is applied. Changing control/switch positions has no effect. You probably have issues with caps in the power supply....I would check that first...open ...
...and everything cuts out. I leave it for a while and it works again but not for long. Seems like an overload problem but but I can't think how it's being overloaded You may be having early stages of ...
i replaced the transformer and fuse which is in a sealed compartment above the power supply connection in djx 700 (behringer) and still have humming in the new transformer Transformers rarely fail... ...
Question about Kustom Music
When you turn on amp it is fine, beautiful clean sound, as it gets hot, about 30 continous minutes becomes mare and more distorted untill the signal fades to almost nothing. It will last almost a set,
My d8b runs and after 5 mn freewes.No more input or output.All the leds on the board go off and no button is active. I suspect the power supply is shutting down... may be overloaded due to failure in ...
4 questions posted
Usually answered in minutes!
10 Questions
7 Questions