...us to Check cassette # 2, reinstall cassette # 2 properly??? it is referring to the paper holder (cassette ), it's expecting to get paper from cassette # 2 check settings for paper source and change ...
...Check Cassette#2" will appear if the 2nd cassette sensor does not detect the paper cassette. So my thinking is that 1: the cassette is not seated in the printer correctly (not trying to be insulting, ...
Question about Brother MFC Office Equipment & Supplies
...copies off the glass not using the document feeder. If they are crooked coming from there check the paper cassette and make sure the side quides are snug against the stack. That is the usual
...Check tray #1. This happened once or twice before and when I checked tray and re installed it , it took care of the problem. Now I can remove and install tray 100 times and will not reset. any ...
Question about Brother MFC Office Equipment & Supplies
...check if you have left any paper in the printers tray disconnect the power cable, remove the paper cassette, turn the printer upside down and PRESS hard at the paper cassette's 2 side guides at the ...
...cassette #2 properly". It is installed properly. Turned machine off. looked inside, no paper jambs, cassette seems to be okay, reinstalled just like 100 x's before... Still same message. Checked ...
Question about Canon Office Equipment & Supplies
...cassette pedistal. check all the connectors. make sure you have programmed the correct size for this unit in additional functions ,make sure of a a4 or ltr selection where ever your at in this
Question about Canon Office Equipment & Supplies
Check to make certain all of the doors on the Cassette Pedestal are completely closed. Note: These doors are located on the lower left side. (2)In service mode: (DORSW1/DORSW2) tested good. Solution :
Question about Brother MFC Office Equipment & Supplies
...Check the drive gears in the paper pickup drive assembly. Replace the pickup drive assembly if the gears are damaged. See Paper-pickup drive assembly. The tray 2 pickup solenoid (SL101) is damaged. 1 ...
...pedestal has been detected, the communication fails to be normal for 5 sec. Remedy: 1.Check the cable. (usualy) 2.Replace the DC Controller PCB (PCB4). 3.Replace the Cassette Pedestal Driver
8 questions posted
Usually answered in minutes!
1,135 Questions
1,012 Questions
743 Questions
623 Questions
406 Questions
