Brother HL-2040 Laser Printer "stop continually going tray" Questions

stop of the tray will shift each time you put the tray back into the machine. Line that back-stop up with the LTR position and then LOCK it in place. In most cases this should resolve your problem. 2)

...the green handle of the drum unit (labeled 1). Lift the drum unit up and then pull it out until it stops. NOTE: If you cannot pull the drum unit out, make sure that the front cover is fully open.

...stop 01 then select system 1, then select problem unit isolation, then select tray 4 your going to unset follow the screen, then your going to do the same process again this time set, if the draw ...

...stop 01 then select system 1, then select problem unit isolation, then select tray 1 you are going to unset follow the screen, then you are going to do the same process again this time set, if the ...

...tray out to stop further pages being printed without jamming the printer up. Then go onto your print queue on your computer and delete the job that is printing 50 pages. If it dissapears then put the ...

...going to engage the rollers to feed the paper but stops before they start and the light continues to flash amber. It will print from the manual feed tray. Turning the printer or computer off does not ...

tray unit, it may be can be reset,the procedure as follow; 1, press "clear mode"( the c in the diamond). 2, enter107 then press and hold down "stop/ clear" key 3, when you enter the sp mode turn power

stop jamming. It jams with fresh paper, paper from the left had feeder, one sheet, multiple sheets in the tray or feeder. We've only printed about 5-7000 sheets so far. Have not tried powercycling the

neopost si 68 stops after loading paper. The document goes into the flexfeed and after a few inches it stops and request that I remove all documents in the folder section and press restart. I clear ...

epson stylus photo not printing cd Printed just fine, then a bit ago stopped. I cleaned the tabs and it began to print again. Now, it has once again stopped. Continues to give the message that the ...