Brother HL-2040 Laser Printer "copier causing smudge side" Questions

...side of the drum has moisture on it.remove the toner and drum and apply a hot air blower on it for some time also clean the printer internally.reinsert the toner and drum. check by printing few pages ...

...causing this, because it's the first time I've replaced the toner since purchasing the printer, so I pulled the toner and drum out again and tilted the toner back and forth some more, thinking that ...

printed sheets come out with blackish/greyish lines on the right side Use follow these cleaning steps for your printer: 1. Open the front cover of the printer and remove the drum/toner unit. 2. Gently

...smudge are usually caused by a too moist environment, or from being placed too near an Air Conditioner vent. Remember that your printer works by heat transfer and your laser. fuser and drum become ...

...causing the dot, by holding the handle of the cartridge and lifting it up and out of the drum unit. Note: We recommend you place the toner cartridge(s) on a clean, flat surface with a piece of ...

...smudge on side of paper when printing quanities Black smudge goes from top to bottom of the page on one side only Hey, Pleas check Black imagine unit,if needed change it. I've found these smudges to ...

...side of the printout. How do I clean it? Check and verify smudging not caused by toner cartridge by removing toner from printer and checking the blue roller. DO NOT TOUCH the roller as oil from ...

...smudge every 2 1/4 inches on left side of every copy about 3/4" in from left side of paper. Replaced cartridge and still have problem. just make sure that there is no wet ink on the feed rollers ...

...my drum...could the smudge or line be on the drum and that is causing my problem? Yes the image drum is the most likely cause, but it is unlikely you will be able to see the defect on it. Replace ...

...side of the page, and I have no idea what could be causing it or how to fix it. Any ideas? The problem could be caused by the photoconductor units. Try to swap the affected photoconductor units (like ...