bow 4 side check for 2 STK 392-110 and fuses resistors around them. Put new heat sink compound with the new STK.
...a shop? You have to also make sure that when you change the IC's that you put plenty of heat sink compound on the back of the IC's and do not use the cheapy IC's that you can get for 20 bucks or ...
...reach of children. 3) The components arrived and I prepared: - soldering iron - solder - heat sink compound (used mainly to fill in a good gap for CPU heatsink inside computer) - and solder sucker ...
...I suggest that you change both chips ( there are 2 of the same ) and remember to use heat sink compound as this is why you not have the problem ( excessive heat destoys electronic components). ...
...service mode either by pushing in sleep button, and V status together. If you did not use heat sink compound then you probably have not hurt the new IC's yet but you should remove them and add the ...
Question about Samsung Televison & Video
...(2) a digital or analog multi-meter or ohm meter to test some resistors, (3) a tube of heat sink compound, (4) some desoldering braid and solder, (5) two STK392-040 convergence amps, (6) possibly
bows down on the bottom and up on the top. I have replaced the heat sink compound on the 2 IC's on the middle circuit board with no success. (On a good note: doing this didn't make it look any
...bows giving a double picture kind of like looking at a 3d show on all channels, make sense? Yes it does, makes a lot of sense. you have the typical convergence amp problem that plagues almost every ...
...parts supplier. When installing the new IC's you will need to clean off the old heat sink compound and apply fresh compound to the back of both IC's. hey, my 50ex12ba has three STK4274. it ...
Question about RCA Televison & Video
...replace resitor around ic usualy bad 2$ total cost 45$max 2hrs time good luck tip buy heatsink compound 3$ ...
4 questions posted
Usually answered in minutes!
269 Questions
273 Questions
232 Questions
195 Questions
159 Questions