...cover: 1. Remove two screws behind the paper slot. Locate the two small slots on either side of the case(about halfway, front-t0-back, and top-to bottom), insert a small screwdriver and release the ...
...remove the upper cover, there are latches on the inside of the cover on both sides that must be pulled to the front, after that there is alatch on the base that must be moved then the T/W will lift ...
Question about Royal Office Equipment & Supplies
remove the top cover to access and replace the ribbon on a Royal Apollo 10 electric typewriter (circa 1972) serial # SP 8000. ????? Thks, The cover either pulls up straight or there is a release lever
Question about IBM Office Equipment & Supplies
...remove cover, but there must be another. Can you direct me to it? Is there a manual available online? Not positive of Model. The type bottom indicates it is Type 6715-001. I believe what you have is ...
...remove the Two yellow stoppers that were on the typewriter while being shipped. I tuen it on and it goes to the left and stays there beeping. On the Brothers make sure the top cover is down. The ...
How do you remove the platen? the remove by various methods, you will have to remove the covers each end of the platen will be caller holding platen in place. ...
remove the ribbon. corr. tape & print wheel. turn on the typewriter. close cover let it home it's self. open cover put in print wheel. close cover let it nome. put in ribbon close cover. try typing if
Question about IBM Office Equipment & Supplies
...Remove covers, covers come off with plastic clips you push in in the back you will see small square holes in rear corners push in and lift cover, Keybord lifts up...board is in middle of the machine ...
Question about IBM Office Equipment & Supplies
...remove the cover from an IBM selectric. IBM selectric , how to get the cover off? First remove the platen. There is a lever at each end of the platen push them down and remove the platen. Then inside ...
...remove top cover On the side of the machine there are slits, push them in with a thin blades screw driver, and lift the cover up. Caution the right light panel will be attached, do not lift that side ...
89 questions posted
Usually answered in minutes!
1,487 Questions
1,353 Questions
1,277 Questions
961 Questions
741 Questions
