...toner is cartridge is low. On the other end of those 4 sensor arms is a foam pad. The glue bleeds through the foam pad, causing the sensor arm sticks to the sensor, causing sensor problems. You have ...
Question about OKI C Office Equipment & Supplies
...down the right side of the page? remove toner and drum unit remove toner check to see if there is toner in the drum unit if not fill unit run 5-10 prints replace dev roller replace drum
Question about OKI C Office Equipment & Supplies
Oki C3200n Says Order K Toner after install I've just installed a new K toner & drum and the display still says "Order K Toner". On printing the menu map that tells me there is over 91% life left in ...
Question about OKI C Office Equipment & Supplies
...remove toner cart. from top of drum, inside drum running the width of top surface is a 2 x 15cm wide slot, it needs to have the toner to the brim of this slot (foam edged), there also needs to be ...
Question about OKI C Office Equipment & Supplies
OKI C3200N laser printer, low toner problems When we recieve the low toner message we take out the toner tap it then put it back in and the printer shuts off. Once you turn the printer back on it ...
...lit and saying failed to get printer information. This was after a paper jam on fuser unit. I've removed the jam and placed back the unit and drums. and the message still . I've removed all the ...
...to clean interior (do it outdoors) 3 - spray toner cartridges to remove stray toner (keep them connected to the drums, do not separate) 4 - make sure toner carts are properly installed and locked ...
...to the waste toner motor not running properly. Remove the waste toner bottle and put a hoover to the outlet to the bottle in case the toner is hard and blocking the exit of toner into the
...the sensor before installing the new toner. Also, while I hate to state the obvious, make sure you removed the tape from the new toner before inserting it. Last, make sure you lock the toner in
Question about OKI C Office Equipment & Supplies
while removing the protective paper from the drum/toner cartridge for the first time, I dropped the drum assembly onto the floor and toner went everywhere. Can I somehow clean up the toner off of the ...
211 questions posted
Usually answered in minutes!
152 Questions
147 Questions
126 Questions
93 Questions
81 Questions