...Error The K ID unit is not operating properly. Check to confirm that Image Drum is seated properly. Check to confirm that the K ID unit is in position. Replace the K ID unit. Replace the K ID
...PERSISTS. I HAVE ALSO CLEANED ALL TONER SENSORS AND HAD PCB'S OFF AND CLEANED AND CHECKED ALL CONTACTS. DO YOU HAVE ANY SUGGESTIONS? Replace Toner and Drum clean everything and it should fix ur ...
...Replace the drum. The error should clear after the print engine has reset. Check the little switch/door on the right hand side of the drums. This has worked successfully for me. Symptom: After ...
...173 what do i do Your printer most likely needs a new drum. Check the page count. Are you close to 15000 pages, then it is time for a new drum.... Jemhadar was right. I have to replace the drum. ...
Question about OKI C Office Equipment & Supplies
...down the right side of the page? remove toner and drum unit remove toner check to see if there is toner in the drum unit if not fill unit run 5-10 prints replace dev roller replace drum
Question about OKI C Office Equipment & Supplies
...Replace Image Drum Unit. Note! 1. When replacing the Engine PCB (S2V PWB), remove the EEPROM from the old PCB, then mount that EEPROM on the new PCB. 2. If the EEPROM is not going to be replaced, ...
...REPLACE TONER, instead they find that just openning and closing lid keeps them going, but these machines hold a complete toner in the drum unit too, so all they are doing is depleting that and when ...
Question about OKI C Office Equipment & Supplies
...drum and waste toner bottle a new message appeared, 940: Fatal Error. What does this mean and how can it be rectified? 940: Error Waste Toner Transfer Error The transfer mechanism of the toner duct ...
...Check the little switch/door on the left hand side of the drums. This has worked successfully for me. Symptom: After replacement of a C3530 Image Drum, the message, "Toner Sensor Error" is displayed. ...
Question about OKI C Office Equipment & Supplies
...paper come from the drum, this could be a circumferential scratch on the drum or a void in the wiper that clears the excess toner. Whatever, you need to check the drum and possibly need to replace
202 questions posted
Usually answered in minutes!
172 Questions
147 Questions
126 Questions
93 Questions
81 Questions