Question about OKI MICROLINE Office Equipment & Supplies
the ribbon is not turning or advancing 1.the ribbon is not turning or advancing so that the ink is not being printed on the paper 2.the dot matrix does impact on the paper 3.if I get a solution to my ...
its not printing Make sure that you have a good ribbon installed and that the ribbon is advancing as the carriage moves. If the ribbon is not advancing it will only print until the ink has been used ...
Question about OKI MICROLINE Office Equipment & Supplies
New ribbon but the printer is still very faded - what can I do next, I have adjusted the spacing and changed the ribbon again but the problem remains. turn the small knurled knob on top of the printer
Question about OKI MICROLINE Office Equipment & Supplies
oki microline 320 printer labels are catching on plastic shield of ribbon. any recommendations? Remove the plastic shield on the ribbon, you may get a bit of ribbon rub, but it's normally not ...
...just changed the printer head and there is no ink coming out of the new printhead. There is a thin ribbon connected from the printer to the print head. Remove it and re-insert in again. If the end
ie.. if it was to print the letter T it would look or like an I. I have replaced the print head and ribbon, any ideas what might be causing this. You have replaced the item which is commonly the cause
Question about OKI MICROLINE Office Equipment & Supplies
I find that we have to change our ribbons very quickly. perhaps a print quality setting needs changing.... Its more likely that the problem is cheap ribbons or old ribbons as they dry out with age.
Question about OKI MICROLINE Office Equipment & Supplies
starts off printing normal than fades. new ribbon in it Check the new ribbon and see if the printer has worn out one spot. If you move the print head manually side to side the blue knob on the ribbon ...
Not ledgible I installed a new ribbon and now I can not read what is being printed unless I load the printed with three sheets of paper. Do I have a printhead problem or have I worn my printer out? ...
...printing very slow. ok, plz first you clean the printer and servicing by using printer oil. printer ribbon mask may be damaged,so you change the ribbon mask. your printer data cable check its ok or ...
61 questions posted
Usually answered in minutes!
259 Questions
51 Questions
17 Questions
20 Questions
17 Questions