...Amp 125 V, and one 4 Amp 125 V I solved this by actually putting 4 fuses from radio shack at 6.3 Amp 250 volts! I went through 2 packs of the 5 Amps and 4 Amps but these finally worked. Good luck - I ...
...part # fd102s this fuse feeds the convergence board both FD101S and FD102S are on the convergence board they are identified as small green or tan resistor shaped components (pico fuse) 3.5 amp 125 ...
Question about Zenith Televison & Video
...125 or 250 v. f800 TV shut off out of the blue and won't turn back on. Replaced lamp, still won't do anything. The fuse on the back of the TV near the power cord is visibly blown. ...
...plug. With a meter it read ok; about 8 inches deeper into the TV on that board was the resister next to two fuses. My 4 amp 125 volt fuse did not read on my meter. After replacing, it worked
...amp 125 volt fuse in there, but does the particular fuse the TV uses have something special about it? If so, where can I get it? None of the local vendors have it. Finally, if the fuse is not ...
...deeper into the TV on that board was the resister next to two fuses. My 4 amp 125 volt fuse did not read on my meter. After replacing, it worked fine. Check all three fuses while you're in
...amp fuse. And I re-soldered all of the flyback points. My tv is working like new. thanks for everyone's help. fl231 is a 125 volt. 400ma fuse rca part number 259513 Can you tell me where in the TV I ...
...and one near a transformer labeled PS8007. All of the convergence circuit fuses are 3.1 amps, 125 volts, and are made by Littelfuse (the 316 series) These are hard to find though, but are ...
amp 125 volt fuse did not read on my meter. After replacing, it worked fine. I need to know how to slise the panel out in the bottom to get proper access to all the boards.I have back cover off I have
8 questions posted
Usually answered in minutes!
154 Questions
129 Questions
91 Questions
84 Questions
61 Questions