...on the newer sets you will have a cross-hatch pattern then you use the remote to set the convergence. THIS SHOULD SOLVE YOUR PROBLEM UNLESS THE CONVERGENCE CIRCUIT HAS A PROMLEM...GOOD ...
...the set every time I turn it on. It doesn't remember the settings if I turn it off (still plugged in). What could be wrong? are you choosing the "Save Multipoint" option after you set the
...a tech i would not recommend getting intoservice mode. but the key is the the convergence has to be set indiviadually for each tuner. You could try autoconverging in digital or even manualy ...
...STK392-110.Convergence circut is located @ frot of set behind speaker grill.The only reset is in the customer menu listed Convergence reset. where is the customer menu list convergence ...
...set convergence now. No fine tuning grid visible. Coarse convergence settings from the service manual will not store and hold. All settings Green Red and Blue show 0 for settings and will not store ...
Question about Mitsubishi Televison & Video
...CHIP USED IN THIS MODEL. TYPICAL BOW FROM CONVERGENCE PROBLEM ANOTHER SET WITH CONVERGENCE PROBLEMS Sd tech please email me instructions for convergence problem for WS-65711. ...
Question about Philips Televison & Video
convergence? With set off Press 0-6-2-5-9-6-Status Set should come up in service mode when done turn power off on front of TV this is to save new settings. there is 3 ways of entering convergence ,let
set the convergences great but after about 10 to 15 minutes ithe reds lines start moving a little again will not stay in position. It's a widescreen Mitsubishi rear projection tv ws-55857. The problem
...Convergence settings are internal to the set on a circuit board somewhere. If you do not have a service manual for this set and some rather expensive equipment, it is unlikely you would be able to ...
Question about Zenith Televison & Video
...set, no audio or video. Initial problem was convergence. Screen displayed 3D characteristics. It says Zenith here and if different let me know----if the convergence failed and took a resistor or fuse ...
53 questions posted
Usually answered in minutes!
154 Questions
129 Questions
91 Questions
84 Questions
61 Questions