Miswiring dc offset Saying miswiring dc offset error i unplug batt radio works for a sec till i turn up then comes back on
...dc meter before the speaker relay(s) to isolate which channel if any, is bad. The protection ckt has a small value electrolytic cap connected to the power supply that needs to be checked. Small so ...
Question about Pioneer Audio Players & Recorders
...dc out" error on Pioneer VSX-108 receiver I was messing around with some speaker connections with my surround sound when the music stopped abruptly. The Receiver now reads "dc out" and I cannot use ...
Question about Marantz Audio Players & Recorders
does this mean and is there a quick fix? Error code POWV5 refers to a problem with the 5 Volt dc supply to the Digital/Audio PCB. If it's not a loose conection then the Main PCB is normaly the problem
...error:It means that microprocessor has detected an abnormal DC voltage:Speaker relay will be Off, then flash "AMP_ERR" on display.If the AC plug is pulled off within 60 sec,and then it is plugged in ...
Question about Kenwood Audio Players & Recorders
...DC OFFSET ERROR) What does thay mean Basically that means there is an overload or some form of power issue with the machine. The best thing to do is reset the unit to start with. Do you have the ...
error message "No power to LNB" on my motor home dish. The dish come up and rotates but then does the emergency store. The manual says disconnect power to receiver then resore. I have done that but it
...error that you are experiencing.I am having a bit of difficulty in locating specific part numbers but feel confident that replacing outputs will remedy your concern.For further info and parts or ...
Question about Pioneer Audio Players & Recorders
error menu. the troubleshooting was found to be Q696 and Q697 in the DC prot. area on "C" board, up near front toward diplay in center of c board. You can get access to error codes on VSX pioneer unit
Question about Pioneer Audio Players & Recorders
...error dc protection chacked all power transistors c2500 ,a1948 all ok i was disconnect dc detector wire then ok after few minutes one pair burned with c945100 ohms resistors that time not fix heat ...
50 questions posted
Usually answered in minutes!
169 Questions
146 Questions
83 Questions
90 Questions
66 Questions