Question about LG Office Equipment & Supplies
...black if the lamp is still on and no picture transmits, reset the settings to factory default. the resolution doesn't match or the signal is lost. if the lamp goes out, you may need to replace the ...
...are 1006. Should I have the lamp replaced? Black spots are more likely to indicate a partial failure of the DLP chip. The lamp cannot produce such a symptom sadly. Repair will be quite
Question about Epson Office Equipment & Supplies
...red under lamp. I have no light nor image. the lamp may not be striking. check the lamp for bulges and/or black spots inside. if there are, replace the lamp. if the lamp is ok, replace the
Question about Boxlight Office Equipment & Supplies
...it on??? please help it's either the lamp or the ballast. check the inside of the lamp. if you have bulges, black spots, flaking or fogging, replace the lamp. if the lamp is ok, replace the
failed to lights up lamp? check the lamp for bulges, black spots or fogging, and replace as necessary. if lamp is ok, replace the ballast.
black and the "temp" and "lamp" alarm lights will flash on and off. I've changed the filter and we very recently changed the lamp (maybe 150 hours of use). if you are replacing the
Question about Sanyo Office Equipment & Supplies
...be running, or the lamp isn't striking. check the fans and check the lamp for bulges, black spots, fogging, or flaking and replace if necessary. if the fans and the lamp are ok, replace the
Question about Sharp Office Equipment & Supplies
...lamp. We are still only getting black and white and said it need a new lamp> reset the settings to factory default. if you have a dlp projector, replace the colorwheel. but you'll need to send it ...
Question about InFocus Office Equipment & Supplies
...is spinneng. if it isn't, the lamp won't strike. if the colorwheel is fine, check the lamp for bulges, black spots, fogging or flaking. replace if necessary. if the lamp is fine, replace the
Question about Optoma Office Equipment & Supplies
...lamp, it's black with a metal contact. If, when the lamp cover is replaced, it does not "activate" this switch for some reason (i.e. it is loose or perhaps bent) then the projector will not power at ...
96 questions posted
Usually answered in minutes!
41 Questions
39 Questions
27 Questions
39 Questions
25 Questions