Rheem M206A 206K BTU Pool and Spa Propane Gas Heater "problems heater lines" Questions

should the pentair minimax pool heater be wired to line or load? should the pentair minimax pool heater be wired on the line or load side of the time clock for the pool pump?? when on the line side ...

...lines cleaned. If there is a blockage of the gas line, you might not be getting enough fuel to start the heater. If that doesn't solve the problem, try consulting the owners manual for these pool ...

Replaced a H100 Hayward pool heater with a H2101Heater.New heater runs 4 about 5 min. Then shuts off including pilot. Filter is clean .getting plenty of water pressure. Gas line has no leaks. What's ...

moved heater from one pool to another an now its not working the induce draft is running an the igniter is glowing an the gas valve opens an you can smell gas so now what You will need to check the ...

...heater. That shuts it down, it gets fresh water and starts again, just to cycle again and again. Problems with the internal by-pass will do this also along with a dirty filter basket or impeller. The ...

i have a pf error on my hayward 400 fdn 2 yr old heater. also it's wired 240 volt ac Thank you for posting your question here on Fixya.com. A 'PF' error code for a Hayward heater is an electrical ...

High-pitched squeal when heater comes on. I know it has something to do with gas flow but I don't have a toggle switch like it says in the manual. I have a round black knob and I'm not

GOT THE HEATER RUNNING FOR 5 HOURS YESTERDAY BUT WHEN I SHUT IT OFF AND THEN TRIED TO TURN IT BACK ON IT WOULD NOT START. THE RED LIGHT IS BLINKING SLOWLY, IT USUALLY IS ALWAYS ON! BARRY Hi Barry, ...

...problems with the element. What you will likely find is an element with infinite or some other reading WAY higher than even 20 ohms. Replacing an electric heater element in a spa heater is a fairly ...

Hayward model H100ID1 pool heater. Pool heater ignites, main burner is on and stays on for 20-30 seconds. 120V to gas valve (purple wire) turns off. I have a new control board problem remains. No ...