...it. To get to the bearing wheel you will need to remove the very long about 10 inch screws (4) from the rear housing. I used a 1 inch pipe to tap the bearing wheel. back on the shaft. Works great
Question about Hayward Pool & Spa
want part number for bearings to motor 1.5 model # C48L2N134B1 want part number for bearings to motor 1.5 hp model # C48L2N134B1 6203 double sealed ball bearings.
ao smith century 1 hp 56y pool pump sqeals for few minutes at start up and then is ok - sounds like bearings - unit 6 yrs - what is fix How do I change the front and back bearings in this pool pump ...
Question about Pentair Pool & Spa
...fine but shuts off and gets very hot what would cause this. bad pump motor It's likely that the bearings in the motor have rusted from sitting up for 6 months. This causes resistance which in
I hear grinding inside my pool pump. It sounds like the bearings might be going bad? The pupm works fine, its just the grinding noise I hear? Thanks for any advice on what to check? It could be either
...1/4 turn counter clockwise. Tap the front housing until it is removed (may need a bearing puller to remove it. Once this is removed, use a bearing puller to remove the bearing. Next, use 12" long ...
57 questions posted
Usually answered in minutes!
774 Questions
131 Questions
104 Questions
113 Questions
87 Questions