Mitsubishi VS-45607 45" Rear Projection Television "adjust convergence" Questions

...Adjust Convergence* * M: Advance "cross" location* * Up, Down, Left, Right* * 3: Exit Convergence* * Status: Abort/Cancel Changes* * M: Begin Convergence* * * * * *Note: video information must be ...

...adjust contrast? The picture is plenty bright, but the contrast is too high and much of the fine detail is lost. Thanks in advance for any assistance. Have you checked all of the resistors inthe ...

...fix it.The set should have in customer menu a limited convergence adjustment with up to nine points where you can adjust---if it will not adjust there in some way----convergence circuit needs

...adjust the convergence it is off and remote wont adjust it? I went to menu and went to convergence and it just wont change it? The convergence board is bad. If the convergence board were still good, ...

...convergence adjust controls will work but not allow good adjustment. Convergence is ok, Hor Drive signal is incorrect. Many do-it-yourselfers mistake the Hor Drive problem in Toshiba RPTV with ...

...adjust convergence. I just get a black screen. I was reading about how I have to save my setting to memory, but I dont't know how. I start by pressing the service sw (s801) button on the convergence ...

...ADJUST is used to center the Customer Convergence grid. A highlighted cross will appear along with the Convergence alignment grid. The highlighted cross should be centered onto the center of the ...

...convergence on the tv, I can adjust the green and the blue to line up but when trying to adjust the red I only can move it up or down. My question is what board control the movement when adjusting ...

...convergence and follow the steps above to adjust the blue pattern. 8. Press OK to exit. You will be asked if you want to save the adjustments Yes Saves adjustments. No Returns to the Advanced ...

...convergence not to adjust properly the red on the convergence adjustment screen will not adjust properly. When the tv is turn off the on again it will change position on the convergence adjustment ...