Procom ML300TBA Heater "air coming propane regulator" Questions

...air in the pipe and the propane will slowly flow upward to be ignited. As the heater's intent is to allow patio use in cold weather, this defeats the purpose. As the ambient temperature rises, the ...

propane not reaching appliances i.e. furnace, water heater and cook stove. tanks are full, what could be the cause. Turn the tanks off outside and take the regulator off the tanks and the main line ...

...Propane and NOT Natural Gas. Check to see if the gas valve on the appliance is in the operate position and all valves are open. Bleed off the air in the gas line by holding down the pilot switch and ...

...Propane) You will also need a manometer or a gas pressure tester to check the incoming and outgoing pressures from the green (2ndary )regulator outside your house to the gas valve inlet side,usually ...

...Propane or Natural gas heaters that are not burning properly can and will emit C.O. (Carbon Monoxide) a deadly gas . When C.O is produced , although odourless in itself , does have a very strong ...

...first time takes several minutes of pressing the pilot button for the air to clear and the propane to come through so it lights. Perhaps you are not waiting long enough for the gas to enter the

...propane. You have to go 10 drill bit sizes smaller. Also the air gap on them burners has to be tweaked. Primary air is added to the lp at the orifice. The gas/air mix has to be close or the nasty ...

...propane molecules are different sizes in the vapor state. The orifice regulates how much vapor comes out. You need to change the orifice in the pilot and the burner injectors for it to work properly. ...

air comes out of firebox when lighting then flame goes out coleman heater What do you have your heater hooked up to? A 20# propane cylinder? Are you using a red high pressure regulator or a silver low

...propane Disconnect & check for blockage in hoses or valves There is probably a regulator valve inside. The pressure is reduced through a small hole in the regulator valve. Is it blocked? Use ...