Mitsubishi WD-62725 62" Rear Projection HDTV-Ready Television "not turn" Questions

...not turn on. Turn it on and there is a TV does not turn on. Turn it on and there is a click, the red timer light comes on for a couple seconds, then it turns off. No picture or sound ever appears. ...

...turn on the light goes red on the status light in the front. what else can it be? If it is not a Mitsubishi lamp it could be that. Aftermarket lamps do not make happy with these TVs. I purchased one ...

...supplly make sure its not the fault in wht this will not turn on. Unplug tv from wall wait 30 secounds and plug back in. If that does not work you will need to have someone look at the

not turn the TV back down using the remote and had to do it on the TV panel itself. As I was trying to turn it down the volume kept going back up. This happened several times during the evening and we

...not turn on and I need to know what I should do? Thank you! Start with plugging the unit out of the wall. Wait. Plug it back in and see if the green flashing lamp stops. If so, try to turn it on ...

...turn on but does not go back to 0-volts (low) after 5 seconds, 12 and 5 volt supplies are good. Suspect the Light Engine part # 939P977010 6. Check for 5-volts DC at J-9 connector pin 1 and 2 on the ...

...not turn back on may need the lamp replaced pt# 915B403001 Recommend Phillips, OSRAM or Mitsubishi original (as from experience others will not work or will have very short ...

...not turn on i have a wd-62528 that will not turn on Try to unplug it for a minute, plug it again and see if the green light blinks for about 2 minutes. After that you will probably be able to turn it ...

...back on only the sound works unplug for about 30 min plugin tv comes on with ever thing working so not turned off for about two weeks Its not dirt, the light engine is failing and this part is not ...

...not turn on???? try to see if you can do a self diagnosis test and if not Power PWB... K9A20 and/or K9A21 are shorted. Also, R9A02 may be open. Possible side effects ... of lamp replacement. DO NOT ...