...Lanier 5635 is a laser unit error code. Often if you power cycle the machine (turn it off with the orange power switch on the left side of the copier, wait a few seconds, then turn it back on) the ...
Question about Lanier Office Equipment & Supplies
...Lanier LD035 duplex unit? The machine says "duplex unit not set" Metal tab on right side of copier is bent and correctly touching the duplex unit interlock switch. Open the duplexer and notice the ...
Question about Lanier Office Equipment & Supplies
LANIER 5637 FAULT CODE SC542 UPON POWER UP You have a Fuser Temperature warm-up error, Hot roller warm-up error. Verify the heater lamps, thermistor and thermofuse continuity. Enter in the SP mode, ...
lanier 5227 scanner error My copier worked fine but now it comes on and there is a scanner error message. I have powered off, unplugged it, turned it back on. It still does it. It says if powering it ...
...lanier 7328/7320. It reads side door open on screen. Only the door is closed. Any suggestions How are you? This is a problem with front door switch. Remedy Place the machine on a level table and make ...
Question about Lanier Office Equipment & Supplies
...lanier copier 5645 for our nonprofit. When we moved it - it won't work. It says the cover is open but its not...help! it won't copy The switch that detects the open cover is probably broken or stuck. ...
...Lanier 5645 copier for our church, it worked fine until we moved it when it was given to us. Now it gives us code sc546 and will not work. Can you please help us??? Try this press the "yellow/ca" ...
Lanier error code 00 Switched two drums..same wrench error code when trying to make a master That is the master clamper area. Take off the rear cover. From the rear it is on the right. There is a ...
...jam yesterday, but can't find any remaining paper inside. Check the point where the door meets the switch on the front of the machine make sure nothing is blocking the switch and that the switch get ...
Question about Lanier Office Equipment & Supplies
Lanier copier 5613 Error Code 549 What is it and how do I reset? Error Code SC549 appears. Tried to clear service code by the following: Clear Mode, then 107, then hold red key. This does not clear ...
108 questions posted
Usually answered in minutes!
629 Questions
382 Questions
267 Questions
215 Questions
218 Questions