sub work, I pulled the cable out of the back of the sub, I can make the sub humm by just laying the cable at the input port on the back of the sub but when i plug the cable all the way in the sub will
...Should it need Line Level, you could replace those jumpers with RCA-cable splitters and share that signal with the internal amp and the Sub amp. If the Sub Amp accepts Speaker Level input, use
Question about Pioneer Audio Players & Recorders
...the Sub-out using a good quality RCA type sub specific if possible cable to your Klipsch Sub. Play with all the levels until you are satisfied. It will take some time to set up properly. Good
cable (or buy one) to split the post vol control signal at this point, and then use line level from here to drive the sub. OR Most powered subs have a speaker "high level" input, where the sub "sniffs
Question about NAD Audio Players & Recorders
...cable) for the Sub Input on the sub (duh): http://www.hometheaterhifi.com/preamplifiers/362-a-secrets-preamplifier-and-power-amplifier-review.html?showall=1 Run RCA from the Preamp Main Out to the ...
Question about Velodyne Audio Players & Recorders
...cable but it makes no difference. I had to switch my amp off and back on to get the green light. Can you help? Tks Here is something to try. On your signal source, check the owners manual for ...
...sub. Ran. John John, Here's the scoop! I presume you have a rack case for all of your gear. If so, Mount the amps (Heaviest stuff) in the bottom, if you have spaces available leave some for ...
I'M HOOKING UP THE SPEAKERS BUT THEY ARE NOT PLAYING, ONLY THE SUBS PLAY, AM I HOOKING THEM UP AT THE WRONG SPOT? check your speaker button in your amp and confirm that it is (on). check your cable ...
Question about Audio Players & Recorders
...cable to the rear r/l input. the sub has sound but that's where it stops. however, it does send my speakers some type of crackling sound every few seconds. and if i turn it up at a very high volume a ...
cable were connected. Can somebody help me...? Hi chupetin2 If the problem is present with ONLY the speakers connected, that is no other powered devices like subs, or input/output cables, it will be a
28 questions posted
Usually answered in minutes!
192 Questions
173 Questions
140 Questions
146 Questions
92 Questions