Question about Electrical Supplies
...a NGK spark plug for my PRO FORCE 106000 Generator Original plug from MFG is LD F5TC - want to replace with a NGK plug NGK - BP5ESChampion - N11YCAutolite - 64Bosch - WR8DCDenco - W16EXUTorch _ ...
...Generator Problem not getting spark to the plug i know that much because i pulled plug and cranked over nothing but i did get zapped when held plug wire in my hand just had gen.worked on by a pro ...
Question about Kohler Electrical Supplies
...pro 27 hp engine. The engine runs but has half the power as it normally does?. Engine starts fine but does not put out the horsepower it should. change your air intake element and also clean your ...
...pro 18 on craftsman riding mower. Idles fine but lacks power at high speed. i installed a new carb. does not seem like it is not opening up full throttle and will back fire if i accelerate the ...
...Pro Leaf Blower, Model No. BVM200VS. (25CC). What is the spark plug gap and also, what is the mixture for the gas and oil? Thanks! Bob Oil to gas. To obtain the correct oilmix ratio, pour 3.2 ounces ...
Question about Kohler Electrical Supplies
the spark plug and see if excess fuel is pushed out when you crank it. If there is then the fuel shut off solenoid on the bottom of the carburetor is leaking fuel into the engine when it's not running
...pro pp4620 avx chain saw won't start chain saw ran fine for over 35 hours of use, then abruptly at half tank chain saw seemed sluggish at which point only 10 minutes later it chugged then died. ...
Question about Coleman Electrical Supplies
...spark at the I Have a pro force 6000 that has no spark at the soark plug First check and see if you have any cracks on the cable then replace the sparkplug with new one but make sure that the setting ...
...it flooding ? is the spark plug wet when you pull the plug after trying to start it ? if it is it could be that a jet in the carb is open too much or leaking, answer back on this post I will check ...
Question about Briggs & Stratton Electrical Supplies
generator. I cannot get it started. It has gas and oil but will not start. What could be the problem Ensure choke is turned on while starting. Ensure spark lead is fully pushed onto plug. Remove spark
6 questions posted
Usually answered in minutes!
4 Questions