Dewalt DC011 AM/FM Radio "board" Questions

...on harman kardon radio on harley ultra classic. Took radio out and found corrision on circuit board on front of radio that display connects to. Need to purchase new circuit board but have not ...

...itwontplay. displayreadsfault 3 Error 3 message means the radio has no power to the main board, one of two places.... jack may be loose on the power / ant board , Contacts may be not ...

circut boards broken I smashed the radio slightly with a pallet and cracked the board for the controlls and the battery power where can , if i can buy new boards. Try this link and Good Luck I hope ...

...are dud, but they charge in my drill charger fine. Have checked both fuses inside on mains board and charger board, both ok. What next ? replaced the circuit board where it meets the ...

...of a way !!! have a look inside your radio at the fuses x 3 1st fuse near transformer on ciruit board, 2nd on circuit board where battery connects to radio and 3rd in the charger its self on the ...

...will not turn on iv changed fusse inside but no joy There are two fuses, one on the power supply board and another on the battery holder board.Check to see that power is going through the switch

...reads good but theres no volume coming out? fuses are good had to replace the one on the power board but other than that everything else looks good? you got anything? are you aware if the AA ...

...my 06 bike does not hold its memory on my 11 bike 2011 RADIOS ARE BEING PRODUCED WITHOUT THE NAVI BOARD. EARLY 2011 MODELS MAY HAVE A ROLLING CHANGE TO THE CIRCUIT BOARD THAT DOES NOT FULLY SUPPORT ...

...the case is entirely free. After the case is open you will have access to the connectors on the RF board. Make sure all 4 connectors are fully seated. There is another connector under the RF board ...

anttena were on the circut board do i soider the wire. It fell off. its the anttena. do you have a pic so I can see where on board it goes. the radio is very special to me. Should be somewhat obvious ...