KitchenAid Architect® KUDT03FT 24 in Builtin Dishwasher "cancel bit" Questions

...am at 10:45, and it was still on the wash cycle at 12:30pm. Seems it was stuck in that cycle,so i cancelled, then did a rinse cycle, which went on for better than 20 minutes- so I cancelled again, ...

...Cancel light will also blink (but can be cancelled by holding button down) I tried shutting down the power and resetting at the breaker. I tried other buttons like Air Dry, etc to see if there was ...

...cancel, remove power for 5 minutes, used the panel sequence "sani - heat - sani - heat" (results in all panel lights go on), but still the door will not latch. I called Kitchenaid, the offer no help, ...

Dishwasher just keeps washing, it doesn't stop or attempt to cycle forward I've cancelled the current cycle and tried to start a different cycle. Nothing happens initially when I close the

...cancel the cycle, thinking that the door has opened, and the lights will flash. After a certain amount of time, it might "time out" and reset and the lights would stop flashing. Unfortunately it's a ...

...bit and may not be accurate. Thank you. GO UNDER YOUR SINK FIND THE DRAIN HOSE COMING FROM THE CABINET IT WILL EITHER BE OFF WHITE OR BLACK FOLLOW IT TO THE DRAIN POINT EITHER AIR GAP DISPOSAL OR ...

...cancel, and start for this model. Any suggestions ? Does it work though? If the light is staying on after you cut power then maybe a genie is living in there :)). Other than that it could be a bulb ...

...cancel does work. i have replaced interface, fuse and control board each time it works for a bit then stops again. an y thoughts Check if because of gasket defects you are getting humidity buildup in ...

...bit of time to start running. The reason being is that the heater in the water tank is heating up the water to above 140 degrees. To test this, cancel the existing cycle and start again shutting off ...