Electrolux EIED55I Dryer "normal cycle run" Questions

...normal.After it cycles once, the ignitor comes back on but there is no flame. The gas valve and ignitor seem to be operating normally at first. Before this problem started there were two ocassions ...

...normal cycle and switch it to Extra dry so it is running for about 59 minutes. After the dryer stops the clothes are still very wet. It usually takes 2 if not 3 cycles before the clothes are ...

...drying cycle. Over time the operator coils 279834 get weak and quit. They are really easy to replace. This short video show a normal Burst of heat from a dry and the normal length of time it fires ...

...run a new cycle, the dryer starts normally with drum turning and blower going, but the heating element will not start its cycle with the igniter heating up and then gas kicking in. If I reset the ...

...ten seconds, then leave, put selector to NORMAL, temperature selector to HIGH HEAT and press START to run the diagnostic cycle. The procedure for this specific model is described in the tech

...the normal cycle. Any ideas as to what might be wrong? I would check the temp switch located in the console panel, sounds lile maybe the contact is burned since you have heat on delicate and

...then leave, put selector to NORMAL, temperature selector to HIGH HEAT and touch START to run the diagnostic cycle. The procedure for this specific model is described in the tech

...away or when the timer runs to the next cycle. The start button does not need to be pressed - it normally did need to be pressed to start the dryer. Thank you! replace ...

...normal wash and never stop washing i let it run for 2 hours and stiil running Your dish washer probably has a "turbidity sensor". This is an infrared sensor that checks the condition of the water and ...

...normal cycle the unit will beep 6 times and continue to run. This happens at random intervals during the cycle. There are no error codes on the display screen. Clothes are drying as they normally do. ...