Orion HCCA 10.2 Car Subwoofer "speaker positive negative terminal" Questions

...speaker) then connect from amps' Positive output terminal to spkr. 1 positive terminal, THEN spkr. 1 neg. terminal to spkr. 2 positive terminal, THEN spkr. 2 negative terminal to spkr. 3 positive ...

POSITIVE LED TERMINAL THE NEGATIVE CAN BE RAN FROM THE NEGATIVE SPEAKER TERMINAL. 2. (INTERMITTENT; COMES ONE EVERY TIME THE BASS HITS) - RUN THE POSITIVE AND NEGATIVE WIRES FROM THE + AND - TERMINALS

...positive speaker terminal, the cone will pop out. If it pops in, then the positive side of the battery is touching the negative speaker terminal. NOTE: A subwoofer should be strong enough to handle ...

...to the positive end of speaker. If the speaker cone pulls inwards, contacts are reversed. That way you insure yourself that on installed speakers, the wiring has not been reversed along the

...speaker witch is positive & negative small or big terminal? which is positive and Negative small terminal or big terminal? Generally, if treminal isn't labeled or colored(red positive, black ...

...positive speaker terminal. One wire from amp negative to negative speaker terminal. This should leave one positive and one negative termianl on the sub. Use one additonal wire to connect these two, ...

...speaker is wired to one channel of the amp. This is series wiring. To get a 2-ohm load, you need to wire in parallel. Here's how: Take sub A and wire the positive terminal to the positive terminal of ...

...Speaker Positive - White Left Front Speaker Negative - White/Black Right Front Speaker Positive - Gray Right Front Speaker Negative - Gray/Black Left Rear Speaker Positive - Green Left Rear Speaker ...

...speaker's 2nd voice coil's positive input. then run from the 2nd voice coil's negative back to the amplifier's negative speaker lead. you will be running for each speaker/amplifier set: amp + to ...

...speaker terminals on my sub how do i wire it up ? bridge it. Put positive wire from amp onto one of hte + terminals, then a negative from amp to the - terminal on the other set. Then run a wire from ...