AudioBahn DUB Mag Audio DUB2502 Car Audio Amplifier "kenwood amp troubleshooting" Questions

Kenwood KAC-9152D Car Audio amp I have a ken-wood kac-9152d car amp and its the same when the bass hits it cuts off for a few then back on again and this repeats its self. the LCD light on the amp ...

...mode due to failed output transistors. To eliminate other possible causes, read through the following page: Troubleshooting - amp going into protect mode Let me know if you have any other

...page should help you determine if you have a problem with the amp or something connected to the amp. Amplifier in Protection Mode - Troubleshooting Let me know if you have any other

Kenwood KAC-729S keeps blowing fuses. Checked all cables, re-ran power, remote, and ground. All good, still blows them at power-up. Hello opey_69a, Here are the troubleshooting steps for fuses blowing

...Kenwood KAC 8103D 1000 watt Amp. I had 3 tens hooked up. Sold 2 of the Tens. Plugged in one and of course blew the 1 Ten. I bought a new 12 to connect to the Amp. But... when I plugged in, the Amp ...

Kenwood KM-208 150W/chan power amp is dead. Can't find owner's manual to locate the fuse. Can someone tell me where the fuse for this thing is? Where can I download a manual from a safe website? I ...

...kenwood amp hooked up to my two type r alpine 10" subwoofers and then it cut out, i checked to see if it was hot and over heated after i got home and it was not even warm to the touch. I was playing ...

...kenwood kac-6104D amplifier.But for some reason wen it turns on then then it turns wright off Hello jayPRICAN, You do not say what kind of speakers you are running on the amp and that can affect how ...

...Kenwood KAC-9152D amp and beeing that i dont use my car much, I dont use the amp much. One day I turned it on and all the amp would do was turn on and off, on and off continusly. I know this because ...

my amp for my car has a steady blinking power light for about a minute then immediately blows the fuse? This one should be quite easy to troubleshoot. Start by disconnection every wire on the amp, ...