Kenmore 22422 Top Load Washer "metal pin" Questions

There are 2 metal braces under the plastic tub and its main brace. There are 3 pins holding these two together. Are those pins supposed to connect the bottom 2 to the main brace under the tub. no - ...

...metal center of the pulley wheel has become disattached. Can this be glued? There should be square notch in the pulley and one in the shaft, this keeps the pulley on the shaft, if that shear pin or ...

...metal lid wtw5500xwg Top lock red button flashes won't stay locked won't run check to make sure nothing is stuck in th hoe where the lock pin goes and that the door is closing all the way. many times ...

...metal parts. You will need to gain access to the MCU (Motor Control Unit), and ohm the motor windings and the tachometer . MCU connection should be as it is in your washer, there should be 5 black ...

...metal parts. You will need to gain access to the MCU (Motor Control Unit), and ohm the motor windings and the tachometer (see images below). The image that shows the MCU connection should be as it is ...

pin or clamp that had spen off, I had tightend it and put it back on, it came off, i did notice metal shavings under the moter. Sounds like the clutch clip came off, the clutch is at the bottom of the

...metal sound when it tries to spin after a rinse. Drum wont spin It is a locked motor error. One of the following is causing the problem but you may need the help of a qualified appliance technician: ...

pin goes into. Check to be sure there is a metal piece visible in that hole. It might also be bent to one side, or broke off. The pin on the underside of the lid MUST push the piece inside the hole on

...pin connector and clean the male side pins. Reassemble in reverse. I followed your instructions and all is well...so far. A few things I would add are: The metal plate that the 4) 5/16 bolts go ...

...metal parts. You will need to gain access to the MCU (Motor Control Unit), and measure the motor windings . MCU connection should be as it is in your washer, there should be 5 black wires and 1 green ...