Kenmore 24032\24036 Top Load Washer "water remains tub done" Questions

water is still in washer when cycle is done Hear water if you spin tub by hand no laundry in washer It’s normal for some water to remain. Is this top or front load? Is it spinning water out of clothes

...water in the tub when you start a cycle then likely there's a malfunction of the pressure sensor. You will need to locate the pressure sensor for your particular model and make sure the tubing that ...

...water remains in tub the door lock will not power up and unlock..what you can try is (if havent already done so) is select the drain/spin only cycle and when the water has drained the door should ...

...remains lit. PLEASE HELP! There is a water pump in the machine which pumps the water out of the outer tub and into the drain, after the wash and rinse cycles. It is possible that this pump isn't ...

...water in the tub, it could be an issue with the drain pump. The drain pump is responsible for removing water from the machine during the spin cycle. Here are some steps you can take to troubleshoot ...

...water remains in the wash tub under the wash basket (stainless steel tub), and resides in the drain line and drain pump. That's why it is important to keep the door slightly open when not in use to ...

...remains locked is going to be a blockage in the drain pump. Here is what to check in the pictures below.Start by unscrewing that just a little and use towel/tupperware tubs and catch the water that ...

...water remaining in the tub. Remove bottom panel to check pump filter for obstructions. Door latch is accessed by removing the front part of the rubber door boot. There is a small spring at the bottom ...

...water remains in the drum the unit will not go into the final spin. There may be a couple of reasons which I have experienced resulting in your problem. If water remains in the tub the unit will not ...