Kenmore 98702 Stacked Washer/Dryer "remove drum bearing" Questions

Ad

Question about Zanussi Washing Machines

3 Answers

...drum wiring ,remove belt (note position) remove motor &, lay to one side, withdraw nylon pins from shock absorbers, Look for and remove the little earthing cable set just inside the pulley rim. ...

Ad

Question about Hoover Washing Machines

1 Answer

...remove the entire drum through the top of the appliance, but before I start a couple of questions. Can someone give me a quick sequence of actions? Can I do this job without a bearing puller/ any ...

Ad

...remove the drum start at the front remove front panel,four screws 2 under front,1 behind soap drawer and the one near the filter,next take door off 4 spring clips on the next panel plus screw on door ...

Question about Zanussi Washing Machines

2 Answers

remove drum pully, refit pully bolt and drift inner drum out having put nut back on drum spider thread to avoid flaring shaft, using hammer knock shaft through bearings, then using a chisel or similer

Question about Washing Machines

1 Answer

Remove the drum from the machine, remove the washer drum, knock out bearings, replace drum spider (shaft) fit the new bearings, and drum seal, put everything back together again. Job for a experienced

Question about Washing Machines

1 Answer

...drum is easier as it has a 'spider asssembly'. remove this after taking off the pulley by taking out the bolts that hold it and bang it off being carefull of the heater element. remove the bearings ...

Question about Hotpoint Washing Machines

2 Answers

...remove the drum from a Hotpoint WM64 washing machine? I need to change the bearings. Remove top cover and rear panel. Remove belt and drum drive pulley.Remove clamp that secures door seal Remove top ...

Question about Candy Washing Machines

2 Answers

...remove the hex nut whiled drum on the frame because it is easy to remove while it is on the frame. 2. Take the complete drum assembly out of the washing machine frame. 3. Leave the drum assy on a ...

have to remove the rear panel and drum pulley to access the drum . shaft and bearing housing. Then depending on the set up, you will have remove whatever screws there are to remove the bearing housing

remove the drum? Yes you do need to remove the drum, it entails stripping the washer down, and it is normal practice to replace the complete drum half with the bearings pre-fitted.. It is not a job to

Not finding what you are looking for?
Kenmore 98702 Stacked Washer/Dryer Logo

1,103 questions posted

Ask a Question

Usually answered in minutes!

Top Kenmore Washing Machines Experts

Michael Thomas
Michael Thomas

Level 3 Expert

3056 Answers

Paul Carew

Level 3 Expert

3527 Answers

Nicola Conroy

Level 3 Expert

1428 Answers

Are you a Kenmore Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...