Kenmore 98702 Stacked Washer/Dryer "remove back panel" Questions

Ad

...remove phillips screws from back side of control panel corners and release clips along top edge of control panel, allowing panel to be taken off and set on top of dryer. Step 3, remove front panel: ...

Ad

Question about Kenmore Washing Machines

1 Answer

remove the base the back stays connected to the frame. just unplug the machine,remove the end caps on your control panel and remove the screws holding it on, them pull slightly forward and up to fllip

Ad

...remove the back panel of the Kenmore Washer model # 11020902990. The spin cycle no longer works. I'm thinking belt replacement, but I can't get the back panel off. if its less than 15 years old its a ...

Question about General Washing Machines

1 Answer

Remove 3 screws holding top panel on back of machine and slide cover back approximately 1 inch and lift off. Completely remove control panel from front panel. Use bungie cord to tie back control panel

Question about Whirlpool Washing Machines

1 Answer

...remove cabinet from back panel. use a screw driver and release clips, unplug any wires going to top panel from rear panel that make hold back cabinet, Cabinet pivots on locator pins on lower front of ...

Question about Kenmore Washing Machines

1 Answer

Remove 3 screws holding top panel on back of machine and slide cover back approximately 1 inch and lift off. Completely remove control panel from front panel. Use bungie cord to tie back control panel

Question about Kenmore Washing Machines

1 Answer

...back panel and remove. HINT: It may be easier to remove the front and back panels to have full access to the MCU from both sides. The following websites have excellent exploded view parts diagrams of ...

Remove bottom screws from plastic parts on the back edge of the washer top. Stand in front of machine and use the palms of your hands to sparply push back the washer's top about 2 inches, then lift it

Question about Washing Machines

2 Answers

...back panel and base frame. 1. Remove two trim caps on either side of the control panel, they are just plastic, and clip in place, either remove by hand, or if they don't come right away you can pop ...

Question about AEG Washing Machines

1 Answer

...back on remove that from the door lip and remove the front panel. the pumps are at the bottom left near where the pump filter door was. remove the relevant one. the recycler is attached to the pipe ...

Not finding what you are looking for?
Kenmore 98702 Stacked Washer/Dryer Logo

1,103 questions posted

Ask a Question

Usually answered in minutes!

Top Kenmore Washing Machines Experts

Michael Thomas
Michael Thomas

Level 3 Expert

3056 Answers

Paul Carew

Level 3 Expert

3530 Answers

Nicola Conroy

Level 3 Expert

1428 Answers

Are you a Kenmore Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...