...drum by hand. If there is a rumble, remove the bearings and replace them with new ones. Check the spider at the back of the drum. The spider is the three-armed device that holds the drum in place. ...
...spider arm which is not easy........ When washer goes into spin cycle, the tub will start to spin, then the tub starts to wobble and then alarm sounds Read this post (and comments!) before throwing ...
Question about Frigidaire Washing Machines
...spider arm supporting the spin-basket (which seems to universally fall apart within 5 years), and now I started observing the described black stain pattern on the clothes. As with the spider arm ...
...spider arm supporting the spin-basket (which seems to universally fall apart within 5 years), and now I started observing the described black stain pattern on the clothes. As with the spider arm ...
...or spin failure. An even more serious consequence of this problem is that the aluminium based drum spiders can be corroded by this grease and in serious cases can cause one or more arms to break. ...
...spider assembly. My Kenmore Elite (model # 110-42822-203) had a kocking problem as well. After taking the back off, I discovered that the nut holding the pulley to the drum shaft (on the outside of ...
Question about Washing Machines
...spider arm is broken. This arm is inside the drum and cannot be seen unless you open up the drum, most likely it is the arm. For the bearings it could be a grinding noise, but the tub will turn if ...
arm spider-ish bracket that holds the inner drum. To test this theory, see if you can lift the inner drum up & down from the door side, you will be able to feel if it is broken. Hope this helps. *
459 questions posted
Usually answered in minutes!
3,839 Questions
3,158 Questions
2,098 Questions
1,642 Questions
1,023 Questions