...that the machine is shifting too hard and the hose that connects to the pump could be leaking check out both of these ideas. If you should have to replace the pump it will run you about
Question about Kenmore Washing Machines
...shifts hard it could be transmission.. A hum in the spin cycle is normal for that machine. You can down load an installation and an owners manual free of charge from sears parts direct. That model ...
Question about Kenmore Washing Machines
...washing machine constantly default to OL which indicates the machine OVERLOADED, but is isn't. The won't drain properly and shuts off leaving my clothes extremely wet. The OL code also means that the ...
...washing machine - any machine I've had before, the agitator goes really fast, and I know the clothes are being cleaned. This one, the agitator seems to leisurely turn, pausing a second between each ...
...machine was level and it is. Any ideas? I had this one come up on a washer I had professionally installed for a client. When I looked into it I found there were shipping blocks made of squeaky ...
machine. Locate the pressure switch, you can identify it by the thin tube attached to it. Take the tube off, blow down this tube as hard as you can to shift any blockage or restriction in the pressure
...washing machine will not spin showing error code f-08. please can you let me know what this means & can I fix it myself. f8 is shown when the heater circuit is on with no water in.. it doesnt do it ...
Question about Miele Washing Machines
...shifts the whole machine. Replaced 4 shocks or struts with commercial grade ones about 6 years ago. Does it need new? could be a couple things - a spring (there are four of them ) that the drum hangs ...
...washing machine so I can give it a good clean before reassembling (and after replacing bearings and seal.) The three nuts that attach the spider to the drum are stuck. Won't budge. Won't shift. Won't ...
...washing machine is a Ariston. Thank you Try and release the RESET button as if this is in contact then the main board will be inactive. So it is important that the motherboard gets the reset to shift ...
4,939 questions posted
Usually answered in minutes!
1,023 Questions
0 Questions
69 Questions
45 Questions
20 Questions