Question about Kenmore Elite Washing Machines
...removing the bottom panel. is there a trick? any help would be greatly appreciated. If you've removed the screws and the panel sticks, tapping on each side will knock it loose. The panel should drop ...
panel and locate the bottom of the door lock and switch assembly on the right side. Locate the tear-drop shaped tab then gently pull it down until a click is heard. You can also remove the door gasket
...bottom panel on a kenmore front loader You remove the lower panel just under the door by removing 3 screws under the curved part 1 each corner and 1 center, once that is done you will have only min ...
panel at the bottom of your machine. There should be 3 screws at the bottom if it. Remove the screws and the panel. Usually there is a service booklet in a ziplock taped to the inside of the panel. If
removing the screws under the bottom front edge. With the screws removed, the panel will drop down, then come off. NOTE: You may have to prop the two front feet of the washer up for better access (a 2
Question about Kenmore Elite Washing Machines
...the top panel: http://www.flickr.com/photos/zenzoidman/125498223/ You can also take off bottom kick panel and unscrew the white drain trap and make sure there are no hidden treasures in the
Question about Kenmore Elite Washing Machines
...bottom front panel by removing the three 9/32 screws from the bottom flange. Pull the panel down and off. The drain pump sits right there at the front of the base. Turn the pump filter ...
Question about Kenmore Elite Washing Machines
...panel at the bottom of machine? Should be three screws at very bottom. Remove with 1/4" nutdriver. Remove panel pump should be on the right. Unscrew the cap (they can be pretty tight but they just ...
Take the lid off and see if it taped to the cross bracket under the lid or remove bottom access panel and look on the back side of it. It may also be one the side wall when you remove the access panel
Question about Kenmore Elite Washing Machines
removing the bottom panel, there are 3, 1/4 inch hex screws at the bottom of the panel. Remove these screws and take off the panel, then reach your hand up behind the top panel on the right side. Your
4,938 questions posted
Usually answered in minutes!
1,023 Questions
0 Questions
69 Questions
45 Questions
20 Questions