Kenmore Elite 45986 Front Load Washer "remove lip" Questions

lip of the right side of the door opening. Remove enough of the door gasket to access the door lock/latch assembly behind the front panel. Remove the three screws securing the door lock/latch assembly

...lip) After removing the cover you will see a white plastic unit with a screw on cover on the front. Unscrew the cover (no tools needed). Pull the cover off then remove the strainer. It will have gray ...

Rubber Seal not Sealing The rubber seal has become unseated. This is at the opening in the washer and when you close the front door you shouldn't get water leaking out. What has happened is that a ...

...front door from leaking has torn causing water to leak out. Can this bellow be repaired or easily removed and replaced without calling a service repairman. The error code means door lock failure.

...remove it from the tub. Once you've done that, the clamp and bellows will be free to take out of the washer. Now you can give all the edges and rims a wipe down with a rag to get rid of any gunk or ...

...lip allow to finish complete cycle should remove most of mold try to this every few months..also leave door open between use to allow moisture to dry out as much as possible like i said YOU ARE NOT ...

I need to take case off oasis He washer. Need manual I need to take case off an oasis HE washer. I do not have a manual. I took the back off to adjust the springs and balancer. Now I need front access

...preventing the clamp from loosening, a few dabs of good super glue helps too and can still be removed (dont use much a few drops in four places is

...Remove the complete drawer. To do this you will have to do one of the following- Top catch- push down the lip/catch at the middle rear and pull the drawer out (that's how our Bosch one is ...

...lip, rremove those, and the top will slide off to the back then up. right on th back wall you will see the mixing valve , depending on the exact model, you should see two screws remove those unplu it ...