Kenmore Elite 45986 Front Load Washer "remove kick panel" Questions

...Remove 3 screws from the bottom front panel and drop it down. The pump will be in front of you on the bottom. There is a lint trap. Undo 3 x 7mm screws on bottom front kick plate. Drop the kick plate ...

...like it is not draining? take the kick panel off and check your pump filter. untwist and see what is inside. you will need a 7 millimeter screwdriver and or a t15 torques to remove the bottom ...

...take the kick panel off. remove 3, 7 millimeter screws the lkick panel will just come off in the very center you will see the pump filter untwist it and you will find your treasures. I hope this ...

...the top off backwards, then you have to take the kick plate(bottom) and the control heading off and there are a few more screws under that to remove the whole front. What exactly are you trying to

...kick panel -- remove three 1/4 inch hex head screws and the panel will come off in your hand. Now, reach your hand up between the upper front panel and the washer drum, keep it on the latch side of ...

kick panel. This is the small panel below the main front panel. Remove it and you'll see a hose coming from the drum to a canister. This is the strainer, and has a screw lid. Caution when opening this

...kick panel ahs to be removed. A bit of a messy job so pls be prepared with paper towels and other absorbent materials. Good luck and Thank you for using FixYa. Happy Holidays. Once I took the back ...

...Remove the front lower kick panel. 3. Reach up along the inside of the front panel and locate the bottom of the door latch assembly. 4. Located on the bottom of the door latch assembly is a tear-drop ...

...remove panel. The tech sheet will be either on the back of that panel or taped to the right bottom side. open it up and locate the FH code info and fix your problem Take the top panel off as well. 3 ...

...kick plate remove,them two screws holding on doorlock remove them, remove outer clamp on door boot,pull panel from the end near were kick was,some of those machines have 3 more screws behind control ...