back panel to get access. If it is in the door then you need to remove the bottom panel or the whole front panel to get access. Google thermal fuse for a pic. Usually caused by blocked or pinched vent
...has a lower panel, the fuse will be in front behind the blower housing. If not, it will be in back just like this pic. Ohm it out or jump it out temp to see if that is the problem. Post back, ...
Question about Kenmore Dryers
...back, 1. Hi Limit (small limit upper right hand side of this pic) the most frequent problem if dryer RUNS but no heat AND you have checked the element and found it to be good. 2. heater assembly. 3. ...
back. Unplug the appliance. remove the rear panel. This is a sweet machine. Very easy to fix. The element comes right off easily (2 screws either side of it). Look for breaks. if the element is kosher
...back of the machine, and check for power ( with a meter) into and out of the thermal fuse, you can see one here,, and also a door safety switch and other ...
...back panel and all those screws out you see to ducts. If the dryer is tipped straight out toward you and the cover is off you want your focus on the left duct. See the pic, two screws on the side and ...
...back to regular the coil will do the same thing - heat up for 10-15 seconds then off again. From this description, does anyone know which part(s) might need replaced? Thanks! Check for a faulty high ...
...correct amount of power. all the thermal fuses are located in the cabinet.the first one i would check is the one located on the back wall behind the drum and just to the right of the heating ...
...won't run if it's bad. Remove the back panel and ohm it out. Or you can jump it temp. to verify that's the problem but don't leave it that way. Check the pic. start there and post
836 questions posted
Usually answered in minutes!
1,329 Questions
1,410 Questions
524 Questions
182 Questions
177 Questions