remove the cassette. 3) To insert a new cassette, place the back end of the cassette on the cassette holder on the carrier and gently press down on the front of the cassette unit it clicks into place.
...the machine this will reset to defalt settings. CAUTION THIS WILL ALSO CLEAR YOUR MEMORY!! If the carrier is hard to move a little light oil on the shaft it slides on may cure the problem. ...
Question about Office Equipment & Supplies
...carrier , pull it towards you and to the left, remove the old ribbon, set the new cassette in place threading it thru the two guides, turn the knob on top to take out slack, move the red handle back. ...
Question about IBM Office Equipment & Supplies
...remove the right dust cover (black inside the T/W below the carrier) next to the R. side frame is the correction set up mech. spray some WD40 on the arms especially where they pivot, they should free ...
...settings, etc., and all little packing protector pieces appear to be removed. Any ideas? On the right side of the typewriter, just beneath the carriage (as you are facing the typewriter) there is a ...
Question about Brother Office Equipment & Supplies
...carrier to the previous position. (make sure the daisy wheel cassette is not inserted backwards. The "ear" should always be on the upper right. improper insertion of the daisy wheel may cause ...
...it, however, there is a beeping noise coming from the typewriter. Dropping is not a good thing. Turn it off and check the carrier to be sure it moves freely, remove and reinstall the printwheel. ...
Question about Smith Corona Office Equipment & Supplies
remove the cassette. 3) To insert a new cassette, place the back end of the cassette on the cassette holder on the carrier and gently press down on the front of the cassette unit it clicks into place.
Question about IBM Office Equipment & Supplies
remove the printwheel, look for dedris in the slot where the P/W is located, check for forgien oblects in the carrier area, put some WD40 on the silver shaft that the carrier slides on. If these don't
Question about Lexmark Office Equipment & Supplies
...of the carrier motor in the right rear corner of the T/W you can reach the front one from inside the T/W the rear one you must remove the case or fish the straw thru the back of the case. ...
63 questions posted
Usually answered in minutes!
100 Questions
69 Questions
35 Questions
13 Questions
0 Questions