Question about Texas Instruments Office Equipment & Supplies
Need to replace battery on TI-30XA. What is No. Screen is very light and difficult to read digits, indicating "weak" battery. I need the number of the battery in order to purchase a new one if ...
Question about Texas Instruments Office Equipment & Supplies
i have a TI-82 how do you replace the battery. Push down the tab and lift off the battery cover on the back of the calculator. To replace the four AAA batteries, simply pull them out and put in new ...
batteries and turn it on again. For the baos problem, just remove a battery, leave it out for about 5 seconds. Before replacing it, hold the del key. Replace the battery while holding the del key. The
Question about HP Office Equipment & Supplies
...batteries: Turn the calculator over and remove the plastic cover over the plug-in card ports (display-end of the calculator). HP recommends to turn on the calculator while replacing the RAM card ...
Question about Texas Instruments Office Equipment & Supplies
replacing? Is something else wrong? Thank you. Yes, the back up battery must be replaced. i had that same prob, but i sent it in 4 repairs. I took out the replacement battery, but it started up normal
calculator will not turn on. How do you replace the battery? it is a TI30xa The TI-30Xa uses two A-76 lithium batteries. Comparable battery model numbers include: Duracell® D357 ...
...to replace them; http://tutorialninjas.net/2007/05/04/replacing-the-battery-in-your-ti-30xa-calculator/ The batteries can cost as much as $5 each, a new calculator can be as low as $10 Good
Question about Texas Instruments Office Equipment & Supplies
how do you open a TI-30Xa in order to replace the battery? To replace the batteries: • Remove slide cover. Place calculator face down. • Using a small Phillips screwdriver, remove screws from back ...
does not turn on anymore The battery does run out. If you go to a CVS, or a Longs or something like that you can get a replacement battery (and some of them even replace it for you). I think you need ...
downNext: Look at circuit board, locate double arrowsFollow directions: "please press "RESET" after replacing battery"I just touched the metal flow solder plate (small circle with squiggles) above the
1,237 questions posted
Usually answered in minutes!
1,912 Questions
1,915 Questions
876 Questions
544 Questions
437 Questions